All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
8-5sp e c I a L f e a t u r e s
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
sp e c I a L f e a t u r e s
Creating or modifying a macro
1
Press <Macro Program>.
1.Set Macro
/
/Enter
2
Press <Enter>.
Select Macro Key
M1:No Command Stored
3
Press the macro key you want to create or modify.
Then press <Enter>.
4
If you are creating a new macro, skip to next step.
If you are modifying a macro already stored, the following two displays will appear.
M1:Overwrite?
Yes Enter
M1:Overwrite?
No Cancel
•Tooverwritetherecording,press<Enter>.
•Tochangeonlythemacroname,press<Cancel>andgotothestep9.
5
The copy standby display appears and the machine begins to beep which indicates the
machine is in the macro programming mode.
Copy Ready 01
Auto Ltr 100%
6
Press the keys exactly as you would if performing a normal operation.
•Themachinebeepsduringprogrammingtoconrmmacroprogrammingmode.
•Youcanprogramupto60steps.Whenyouexceed60steps,themachineasksif
you want to register the operations you have entered.
Too Many Steps
Yes Enter
Too Many Steps
No Cancel
If you want to register them, press <Enter>.
If you want to abort, press <Cancel>.
•
When you press <Enter> or <Start> at the end of the operation you are program-
ming, the machine shows:
Include Start/Enter?
Yes Enter
Include Start/Enter?
No Cancel
If you want the machine to start the programmed operation immediately by press-
ing the macro key, press <Enter>.
If you want the machine to prompt you press <Start> or <Enter> before starting
the recorded operation, press <Cancel>. Then go to the step 8.
7
Press <Macro Program>.
M1:Name ;Upper
_
The machine prompts you to enter the name of macro.
If you do not want to enter or change it, skip to the step 9.