All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
8-6 sp e c I a L f e a t u r e s
8
Enter the macro name by using the numeric keys. (If necessary, review “Entering
characters” page 2-2) It can be store up to 130 characters.
9
Press <Enter> to finish.
NOTE: To print a list of macro keys, press <Menu>, <5>, <1>, <1>, <8>, then <Enter>.
Erasing a macro key
1
Press <Macro Program> twice.
2.Erase Macro
/
/Enter
2
Press <Enter>.
3
Press the macro key you want to erase.
4
Press <Enter>. The following two displays will appear:
M1:Erase Macro
Yes Enter
M1:Erase Macro
No Cancel
5
Press <Enter> to erase the macro.
If you want to quit without erasing, press <Cancel>.
6
To erase another macro, repeat procedures from step 3.
Press <Reset> to return to standby mode.
Macro key speed
You can adjust the macro key speed.
1
Press <Macro Program> three times.
3.Macro Speed
/
/Enter
2
Press <Enter>.
3
Press <q> or <p> to select the mode you want appears. The possible settings are
“Normal”, “Slow” or “Fast”.
4
Press <Enter> to save the setting.
5
Press <Reset> to exit.