All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
9-3se c u r I t y f e a t u r e s
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
se c u r I t y f e a t u r e s
Security reception
Security reception tells your machine to keep all received faxes in memory (but not print
them). You can print them out later at your convenience. For example, you could use this
if you are concerned about workers reading documents intended for your eyes only.
NOTE: For this feature to work, you must have activated the passcode protection as
described in the left column. You must also know the passcode.
Activating security reception
1
Press <Menu>, <2>, <2>, <1>, <1>, then <Enter>.
Security Rx
Enter Passcode :****
2
Use the numeric keys to enter the protection passcode.
3
Press <Enter>.
Security Rx :Off
/
/Enter
4
Press <q> or <p> to select “On”.
5
Press <Enter>. The machine shows the machine’s current clock setting:
Security Rx
Enter Time: 15:42
6
Use the numeric keys to enter the time (use a 24-hour format) for the machine enter
the security reception mode in every day.
To change a digit, press <t> to move to the left, or <u> to move right.
Then enter the correct digit.
7
Press <Enter>.
Turning the security reception on immediately
The machine will enter the security reception mode automatically at the predetermined
time.
However, if you want to put the machine into security reception mode immediately,
you can do this by the following procedure:
NOTE: To enable the following procedure, the security reception feature must be set to
active. (See “Activating security reception” above.)
To turn the security reception on immediately:
1
Press <A
dvanced Functions> repeatedly until “Security” appears, then press
<Enter>.
– or –
Press the soft key assigned to
“Security” .
Security
Enter Passcode :****
2
Enter the four-digit passcode.
If you are using the soft key, skip to step 5 after you entered the passcode.