All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
9-6 se c u r I t y f e a t u r e s
2
Use the numeric keys to enter the four-digit protection passcode and press <Enter>.
01:PIN Number
_
3
Use the numeric keys to enter the PIN and press <Enter>.
4
When you finish, press <Reset>.
NOTE: While in Mode 1, any autodialer numbers you use must include the PIN. This also
applies to autodialer numbers used with batch transmission. (See page 4-14.)
If you choose “Mode 2”
In Mode 2, you do not have to add the PIN to the autodialer setting. Instead, you can
enter the PIN manually each time you autodial:
1
Dial the number as you normally would, using the autodialer.
The machine now asks for the PIN:
Enter PIN Number
_
2
Use the numeric keys to enter the PIN and press <Start>.
Your machine will dial the number.
Dialing from the numeric keypad while using the PIN mask
If you choose “Mode 1”
1
Enter the phone number, then press the <
*
> key and enter the PIN.
The PIN always goes last.
For example, to dial 19725550911 with a PIN of “123456,” enter 19725550911
*
123456:
Press Start
13725550911*123456_
2
Press <Start>. The PIN disappears from the display, and your machine dials the
desired phone number.
If you choose “Mode 2”
1
Enter the phone number as usual.
Press Start
13725550911_
2
Press <Start>.
Enter PIN Number
_
3
Use the numeric keys enter the PIN and press <Start>.
Your machine dials the number.