All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
12-8 Ma I n t e n a n c e & pr o b L e M s o L v I n G
Troubleshooting
Document jams
Case 1:
If a document jams in the ADF, the following message will be displayed.
Open&Close ScanCover
Reset Document
Also, if a document jam occurs during a quick memory transmission or real time trans-
mission, the following check message will be printed to tell you which page is jammed.
Case 2:
If a document jams while scanning into memory for sort copy or normal memory trans-
mission, the machine will show:
Document Jam
ContStor Enter/Cancl
1
If you want to continue the operation, press <Enter> and proceed to step 2.
To abort the operation, press <Cancel>.
NOTE: If the machine is left idle for 3 minutes, the machine will abort the operation auto-
matically
2
The machine will show which page (i.e., which page number) is jammed. Clear the
document jam and reset document in the ADF from the jammed page forward, then
press <Start>.
p 2. Reset Document
Press Start key
NOTE: • Ifthemachineisleftidlefor3minutes,themachinewillbegintosendorcopy
the document(s) it has.
•Ifyouwishtocancelthisoperation,press<Stop>.Themachinewilldeleteall
pages from memory and then return to the standby mode.