All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
12-19Ma I n t e n a n c e & pr o b L e M s o L v I n G
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
Ma I n t e n a n c e & pr o b L e M s o L v I n G
T.4.1 The telephone line disconnected during transmission because of excessive
modem errors or because the remote unit ran out of paper. Try the call
again.
T.4.2 After transmission began, poor line conditions developed. Try the call again.
T.4.4 Poor line conditions prevented transmission. Try the call again.
T.5.1, ECM transmission failed (perhaps due to line noise). Conditions can change
T.5.2, rapidly, so try the call again later.
T.5.3
T.8.1 A compatibility error occurred.
T.8.10 Line noise or other problems prevented line probing.
T.8.11 The remote fax machine didn’t complete the equalizer training phase.