All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
2-15Ge t t I n G s t a r t e d
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
Ge t t I n G s t a r t e d
Loading paper into the bypass tray
When you need to use a paper size that is not currently loaded in the paper cassette, or
when you want to print on a envelope, transparency film or custom sized paper, use the
bypass tray.
NOTE: Only use print media specified under “Acceptable paper size” on page 2-12 to avoid
paper jams and print quality problems.
1
Open the bypass tray on the right side of your machine. Unfold the paper support
extension.
2
To set the paper, 1) raise the flapper release lever 2) load paper until it comes to a stop.
3
1) Adjust the paper guides to fit the paper, 2) then lower the flapper release lever.