Specifications

3-42
Unique Switch b:6 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 1 Available *, # and space
upon F-code SUB/SEP
registration
0: No
1: Yes
Determines if checking the * (asterisk), # (sharp)
and space upon F-code SUB/SEP registration.
6 1 Available *, # and space
upon F-code communicating
0: No
1: Yes
Determines if checking the * (asterisk), # (sharp)
and space upon F-code communicating.
5 0 Available space in F-code ID
0: No
1: Yes
Determines if checking the space in F-code ID.
4 1 F-code sub-frame off
0: Send
1: Not send
Do not send the sub-address and password of F-
code box at the point of sending DCS signal after
EOM signal.
3 0 Send F-code box’s TTI
0: No
1: Yes
Transmit the sub-address and box name of F-code
box with F-code polling document.
2 0 Factory use only
1 0 Retrieve document
0: No
1: Yes
Retrieve the document received in F-code
SecureMail box by polling transmission.
0 1 Ignore F-code bit
0: No
1: Yes
Neglect SEP bit of DTC signal or SUB bit of DCS
signal at F-code polled transmission.
Note: The “F-code communication” is possible the SecureMail and Polling operation using the F-code
(SUB/SEP/PWD/SID). However, it is not based on T.33 recommendation.
Unique Switch b:7 — Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Factory use only
1 1 JBIG transmission
(Only for MFX-1700/1600)
0: No
1: Yes
Determines how documents are stored in memory
for transmission.
0 0 Factory use only