All in One Printer User Manual
Table Of Contents
- Preface
- Emergency first aid
- Manufacturer
- Contents
- Notes, cautions and warnings
- About this guide
- Introduction
- Getting started
- Paper recommendations
- Loading paper
- User authentication and access control
- Operation
- Copying
- Scanning
- Scan to e-mail
- Scan to network PC
- Scan to USB memory
- Scan to local PC
- Scan to remote PC
- Managing profiles
- Managing the address book
- Setting sender and reply to e-mail addresses (from/reply to)
- Creating e-mail templates
- Adding an e-mail address entry to the address book
- Deleting an e-mail address entry from the address book
- Modifying an e-mail address entry from the address book
- Adding a group entry to the address book
- Deleting a group address entry from the address book
- Modifying a group address entry from the address book
- Printing
- Faxing
- Functions common to copy, fax and scan operations
- Maintenance
- Installing upgrades
- Troubleshooting
- Specifications
- Appendix A - menu system
- Index
- Muratec contact details
Faxing > 77
7. Press OK to select Register.
8. Select a type of F code box:
> Bulletin Box - refer to “Registering an F code Bulletin box” on page 77
> Confidential Box - refer to “Registering an F code confidential box” on page 77.
Registering an F code Bulletin box
1. Press OK to select Bulletin Box.
2. Press the Right arrow key to select Box Name.
(a) Using the arrow keys and on screen keyboard, enter a box name.
(b) Highlight Done and press OK.
3. Using the Down arrow, scroll to Sub-Address and press the Right arrow key.
(a) Using the keypad enter the sub address.
(b) Highlight Done and press OK.
4. Using the Down arrow key, scroll to I.D.Code and press the Right arrow key:
(a) Register an ID Code number (4 digits) using the numeric keypad.
(b) Press OK.
5. Press OK to complete.
Registering an F code confidential box
1. Press OK to select Confidential Box.
2. Press the Right arrow key to select Box Name.
(a) Using the arrow keys and on screen keyboard, enter a box name.
(b) Highlight Done and press OK.
NOTE
If using one-byte characters, up to 16 characters can be registered.
NOTE
A sub address can be registered using up to 20 digits. Numbers, # and * can
be registered.
If you make a mistake when entering the digits, press the Clear button to
delete and then enter the correct digit.
NOTE
The ID code is not displayed, write it down and keep it safe!
NOTE
If using one-byte characters, up to 16 characters can be registered. If using
double-byte characters, up to 8 characters can be registered.