All in One Printer User Manual
Table Of Contents
- Preface
- Emergency first aid
- Manufacturer
- Contents
- Notes, cautions and warnings
- About this guide
- Introduction
- Getting started
- Paper recommendations
- Loading paper
- User authentication and access control
- Operation
- Copying
- Scanning
- Scan to e-mail
- Scan to network PC
- Scan to USB memory
- Scan to local PC
- Scan to remote PC
- Managing profiles
- Managing the address book
- Setting sender and reply to e-mail addresses (from/reply to)
- Creating e-mail templates
- Adding an e-mail address entry to the address book
- Deleting an e-mail address entry from the address book
- Modifying an e-mail address entry from the address book
- Adding a group entry to the address book
- Deleting a group address entry from the address book
- Modifying a group address entry from the address book
- Printing
- Faxing
- Functions common to copy, fax and scan operations
- Maintenance
- Installing upgrades
- Troubleshooting
- Specifications
- Appendix A - menu system
- Index
- Muratec contact details
Faxing > 79
Deleting an F code box
1. Press the SETTING button on the control panel.
2. Using the Down arrow key, scroll to Admin Setup and press OK.
3. Using the arrow keys and on-screen keypad, enter the Administrator password.
Highlight Done and press OK.
4. Using the Down arrow key, scroll to Fax Setup and press OK.
5. Using the Down arrow key, scroll to Fcode Box and press OK.
6. Using the arrow keys, scroll to the required entry position and press OK.
7. Using the Down arrow key, scroll to Delete and press OK.
8. Using the arrow keys, highlight Yes to continue or No to cancel.
9. Press the OK button to execute.
Transmission using a sub address (F code transmission)
By entering a sub address and ID code, F code confidential transmission, F code bulletin
transmission and F code polling transmission can be performed.
1. Place your document(s) with text face UP in the ADF or face DOWN on the glass.
2. Press the Fax button on the control panel to prompt the Fax Ready screen.
3. Press OK to select Fax.
4. Using the Down arrow key, scroll to Fax Functions and press OK.
5. Using the Down arrow key, scroll to Fcode Tx and press OK.
6. Using the arrow keys, scroll to Yes and press OK.
7. Using the numeric keypad, enter the sub-address of the box registered in the
recipient machine.
8. Highlight Done and press OK.
9. Press the Left arrow key to exit.
10. Press OK to select Add Destination.
11. Using the arrow keys, scroll to the required destination input method and press OK.
12. Specify a destination.
13. Press OK to complete.
14. Press the Mono button to start sending your document(s).
NOTE
You cannot delete an F code box in which documents are stored, it must be
empty.
NOTE
Before operating, ensure you have the necessary sub address and ID code to
hand.