Operating instructions

IF-200 from Muratec
24
6.2. System Settings
To change any of these settings, press SETUP from the Main screen. Scroll to System
Settings and press EDIT. Use the scroll keys to move to the field you want to change
and press EDIT. Make the change and press OK. Press ESC until you return to the
Main screen.
Table 3. System Settings and Options
SETTING OPTIONS AND DESCRIPTION (Default settings are in
BOLD type)
DATE Current date.
TIME Current time.
Time Zone Time zone for your geographic region.
Time Display
AM-PM, 24-HR. Whether you want time displayed in
military (24-HR) or 12 hour (AM-PM) time.
Phone Dialing Prefix Digit(s) to be dialed prior to any phone number stored in the
IF-200 (i.e. 9).
Netmask IP Address Network mask.
Gateway IP Address IP address of router.
IF-200 Address
Static, Use DHCP, Use RARP, AUTO ASSIGN IP. You may
specify a static IP address, use DHCP to obtain an IP address,
use RARP to obtain an IP address, or auto assign an IP
address. When the IF-200 auto assigns an IP address, it first
uses DHCP and then RARP (if DHCP fails) to obtain an IP
address.
E-Mail Header
Normal, Don’t Print, Verbose. Dictates whether the e-mail
header (text) is printed to the fax machine or stripped.
Print Errors
Yes, No. If enabled, prints errors on the fax machine as they
occur.
Dial Method
Tone, Pulse-10, Pulse-20. The method of dialing supported by
the telephone lines in your geographic region.
Need Dial Tone
Yes, No. Whether or not the IF-200 data modem used to
connect to the Internet waits for dial tone before dialing the
phone number. In some countries the dial tone is weak and
should not be waited for.
Insert Comma After 9
Yes, No. Whether or not a comma should be inserted after 9
when it is the first digit of a phone number dialed on the fax
machine.
Poll Mode
Periodic, Scheduled, Disabled. Determines whether the IF-
200 checks for mail according to the Poll Interval, the Poll
Schedule or not at all.