Power Supply Installation Instructions

ManualsBrandsMurphy ManualsPower SupplyPVS-5

00-02-0645

01-21-09

Section 78

In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time.

MURPHY, the Murphy logo, MurphyLink

™

and PowerView

™

are registered and/or common law trademarks of Murphy Industries, Inc. This document,

PVS-5 Power Supply – Installation Instructions

• Provides 5 Volt power supply to PVM gages

• Capable of supplying power to a maximum of 6 PVM gages

• Enables PVM gage compatibility with existing MurphyLink products

• Easy mounting and installation

External power is required to make the PVM gage line compatible with existing

MurphyLink products, i.e. PV1000, Cascade, iGUARD and eGUARD. The PVS-5

power supply device supplies 5 Volts of external power and load dump

protection for up to 6 PVM gages. The maximum length of the power and data

connection between gages is 0.5meters (8.5 meters total).

The unit may be installed inside a panel or behind a dash.

Product Dimensions

Specifications

Input Voltage:

• 6 VDC minimum to 32 VDC maximum

• 12/24 VDC Nominal

Output Voltage: 5 VDC @ 450mA maximum

Reverse Polarity Protection: -36VDC

Overvoltage Protection: +36VDC and above

Overcurrent Protection: 600mA @ 36VDA

maximum

Connector: AMP 1-770968-1

Operating Temperature: -40°F to 185°F (-40°C to +85°C)

Storage Temperature: -40°F to 221°F (40°C to +105°C)

Random Vibration: 5-2,000 Hz

Operating Shock: 50G

Certification: CE

Case Material: Polyamide

Dimensions: 2”x2”x.75”

Mounting Hole Dimensions: Two #8 screws,

1.625" offset

Summary of content (2 pages)

PAGE 1
00-02-0645 01-21-09 Section 78 PVS-5 Power Supply – Installation Instructions • Provides 5 Volt power supply to PVM gages • Capable of supplying power to a maximum of 6 PVM gages • Enables PVM gage compatibility with existing MurphyLink products • Easy mounting and installation External power is required to make the PVM gage line compatible with existing MurphyLink products, i.e. PV1000, Cascade, iGUARD and eGUARD.
PAGE 2
Mounting The PVS-5 can be mounted under or behind the dash using cable ties or screws. Refer to the following installation examples when mounting the power supply device. CAUTION: The mating connector does not have a water tight seal. If the device is mounted in a location exposed to the risk of moisture, then the device should be mounted in an orientation that will protect the connector from water seepage (connector facing down) or sealed against moisture.