InstructionBook Manueld'instructions Manualde instrucciones Snow Thrower Model 620301x4C chasse-neige module 620301x4C Quitanieves modelo 620301x4C Read and keep this book for future reference. This book contains important information on SAFETY, ASSEMBLY,OPERATION,AND MAINTENANCE. Lisez et conservez ce manuel pour r_f_rence. Ce manuel contient des informations importantes concernant la SECURITE, LE MONTAGE, L'UTILISATIONET L'ENTRETIEN. Lea y conserve este manual para referenciasfuturas.
NOTE: This unit is equipped with an internal combustion engine and must not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
_2 5 4 3 4 7 5 / 5 / F_O1133M 14 3
Z 2 ,/ 8_ 2 2 f 3 1 \ 1 1 1 2J% 11 12 2 4 } 5 Fq)O1133M 4
13 14 3 2 1 5 )111111_ 6 4 15 3 4 5 1 17 Fq)O1133M 5
ENGLISH CONTENTS PRODUCT INFORMATION OWNER'S INFORMATION INTERNATIONAL PICTORIALS ASSEMBLY OPERATION MAINTENANCE MAINTENANCE CHART TROUBLE SHOOTING CHART 6 6 7 9 10 12 12 14 TWO YEAR LIMITED WARRANTY Murray, Inc.
ENGLISH INTERNATIONAL PICTORIALS IMPORTANT: The following pictorials are located on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each pictorial. 18 Safety Warning Symbols DANGER Thrown Objects. Keep Bystanders Away, DANGER Thrown Objects. Keep Bystanders Away.
ENGLISH Safe Operation Practices for Snow Throwers As Recommended By: American National Standards Institute. IMPORTANT: Safety standards require operator presence controls to minimize the risk of injury. Your snow thrower is equipped with such controls. Do not attempt to defeat the function of the operator presence control under any circumstances. Training 1. 2. 7. Never attempt to make any adjustments while the engine (motor) is running (except when specifically recommended by manufacturer). 11.
ENGLISH ASSEMBLY 6. Turn the chute deflector (5) around toward the front of the snow thrower. Read and follow the assembly and adjustment instructions for your snow thrower. All fasteners are in the parts bag. Do not discard any parts or material until the unit is assembled. assembly maintenance to the WARNING: orBefore doing any snow thrower, remove the wire from the spark plug.
ENGLISH OPERATION How To Start NOTE: Illustrations begin on page 3. Know Thrower Your Snow (Figure 6) Read this Instruction Book and safety rules before operation the snow thrower'. Compare the illustration with your snow thrower to familiarize yourself with the location of various controls and adjustments. snow thrower result inofforeign ,_ WARNING: Thecan operation any objects being thrown into the eyes, which can result in severe eye damage.
ENGLISH 13.(Electric Start) First disconnect the power cord from the three-hole receptacle. Then, disconnect the power cord from the switch box (11). NOTE: In temperatures below 8°F, allow the engine to warm up for several minutes before blowing snow. indoors or in enclosed, poorly venARNING: Never run the engine tilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.
ENGLISH MAINTENANCE CUSTOMER CHART RESPONSIBILITIES SERVICE RECORDS Fill in dates as you complete regular service. Check And Tighten All Screws and Nuts Before Each Use ' N/ First 2 Hours Every 5 Hours • Every 10 Hours . Every 25 Hours Each Season . Before Storage SERVICE DATES .. Check Spark Plug Check Fuel Drain Fuel .......
ENGLISH How To Replace The Spark 1. Drain the fuel tank. Plug NOTE: This spark ignition system meets all requirements of the Canadian InterferenceCausing Equipment Regulations. 2. 3. NOTE: This engine complies with all current Australian and New Zealand limitations electromagnetic interference. The spark plug is housed in the engine compartment under the top cover and cannot be seen under normal conditions. 1. Remove the top cover. See "How To Remove The Top Cover". 2.
ENGLISH TROUBLE SHOOTING CHART TROUBLE CAUSE CORRECTION Difficult starting Defective spark plug. Replace spark plug. Water or dirt in fuel system. Use carburetor fresh fuel. Engine runs erratic Blocked fuel line, empty gas tank, or stale gasoline Clean fuel line; check fuel supply; add fresh gasoline Engine stalls Unit running on CHOKE. Set choke lever to RUN position. Engine runs erratic; Loss of power Water or dirt in fuel system. Use carburetor fresh fuel.
PartsList- Model 620301x4C Listedepi_ces-ModUle 620301x4C Listadepartes- Modelo620301x4C F_O1133M 33
MODEL 620301x4C REPAIR PARTS ENGINE ASSEMBLY 10 12 11 11 14 25 12 28 14 42 7O 71 40 72 73 47 75 33 45 41 342519E Key No. Description No.
MODEL 620301x4C REPAIR PARTS FRAME COMPONENTS ASSEMBLY 11 I 112 10 14 113 92 114 9O 92 91 342516 Key Fq)01133M Description No. Part No. 8o FRAME SIDE SUPPORT RH 760272-853 81 FRAME SIDE SUPPORT LH 760271-853 9o ROD, SUPPORT 760169 01 WASHER, 71063 02 NUT, 3/8-16 lOO BRACKET, GAS TANK 578093-583 lol SCREW, 1/4-20X.75 180020 lO2 NUT, 1/4-20 782585 11o TANK, FUEL 111 SCREW, 1/4-14X.88 112 CAP, GAS-RED 1257 113 TUBING 11.50 IN.
MODEL 620301x4C REPAIR PARTS TOP COVER ASSEMBLY 172 157 ® 170 ® 141 143 145 152 127 151 153- 313937 Fq)O1133M 36
MODEL 620301x4C REPAIR PARTS TOP COVER ASSEMBLY Key Fq)O1133M Description No. Part No. 12o COVER, BOTTOM 121 SCREW, 1/4-20Xl 122 WASHER, 124 NUT, 1/4-20 126 COVER, CARB 326212 127 SCREW, 1/4-14X.
MODEL 620301x4C REPAIR PARTS AUGER HOUSING 511 512 488 510 531 534 541 520-2 520-8 520 342517 F_O1133M 38
MODEL 620301x4C REPAIR PARTS AUGER HOUSING Key Fq)O1133M Description No. Part No. 48o HOUSING, ASSY 330312 481 SCREW, 1/4-20X.75 302628 482 WASHER, 71067 483 NUT, 1/4-20 486 SCREW, 1/4-20X.63 11871 487 BRACKET, STOP 331126 488 WASHER, 331211 489 NUT, 1/4-20 490 BLADE, SCRAPER 334031 491 RIVET, OVSET .250DIAX.61LG 577707 492 SCREW, 1/4-20X.75 302628 493 NUT, CNTRLK 1/4-20 302635 51o BEARING, 577023 511 SCREW, 1/4-20X1.
MODEL 620301x4C REPAIR PARTS DISCHARGECHUTE 591 \ \ 591 \ /603 X \ X 605 592 / / / 604 .......... 590 / \ /606 \ \ 592 JJ ......REF. ITEM HOUSING 313939 Key Fq)01133M Description No. Part No. 580 RING, CHUTE 314239 581 SCREW, #10X.50 HHTAPPST 711752 582 GUIDE, CHUTE 577021 590 CHUTE, LOWER 334234 591 SCREW 1/4-20X.50 313686 592 NUT, CNTRLK 1/4-2 302635 6o0 CHUTE, UPPER 325847 6Ol WIRE, HINGE 308931 6o2 BOLT, 5/16-18X1.
MODEL 620301x4C REPAIR PARTS WHEELS 650 651 660 661 334309 Key Fq)O1133M Description No. Part No. 65o AXLE SHAFT 313678 651 WASHER, 583409 66o TIRE & RIM 760713 661 WASHER, 583409 662 RING, RET E FLAT .391X1.OOX1.25 FLAT .391X1.OOX.
MODEL 620301x4C REPAIR PARTS HANDLE ASSEMBLY 764 763 750 752 752 762 753 753 753 752 751 759 755 5HP OPTION 3HP OPTION 342532 Fq)O1133M 42
MODEL 620301x4C REPAIR PARTS HANDLE ASSEMBLY Key Fq)01133M Description No. Part No.
MODEL 620301x4C REPAIR PARTS CHUTE ROD ASSEMBLY 874_ 860 ...... _<_ 853 851 \ i as? "857 855 870 REF. ITEM LOWER HANDLE /............ 863 864 313942 Key F_O1133M Description No. Part No. 85o ROD, ASSY UPPER CHUTE CONTROL 314996 851 WASHER, 71072 FLAT .406X.81X.066 852 PIN, COTTER .094 DIAX1.09LG 71082 853 WASHER, CURVED SPRING 313431 855 WASHER, FLAT .406X.81X.066 71072 856 KNOB, SLEEVE 57082 857 NUT, PUSH 331532 86o BOLT, EYE 3/8-16X2.
Fq)O1133M 45
Fq)O1133M 46
F_O1133M 47
MURRAY,INC. CENTRALPARTSDISTRIBUTORS DISTRIBUTEURSREGIONAUXDE PIECESMURRAY,INC. DISTRIBUIDORESCENTRALESDE PIEZASDE MURRAY,INC. BEBCO, INC. CHILTONAIR COOLED ENGINE GULF COAST ENGINE, INC. 22212nd.Ave. South Birmingham,AL 35233 (205) 251-4600 1-800-828-8094 Alabama,Florida,Georgia,PuertoRico 319 4th. Ave.South P.O.Box 150806 Nashville,TN. 37215 (615) 254-1637 1-800-621-6934 www.chiltoncom panies.
