Manual

UniWire Manual Supplement 23 Muse Research, Inc.
3 Open the editor for that UniWire˛FX and tell it to Send data to the Receptor channel you just congured to
listen to the UniWire audio input.
To send MIDI from your host sequencer to Receptor over UniWire:
1 On Receptor, congure those channel(s) on which you want to receive and process the incoming MIDI.
For example, if you want the data to play the Minimonsta plugin on Receptor Channel 1, then choose Minimonsta
from that channel’s Source selector.
2 In your host sequencer, instantiate a UniWire˛Instrument on the MIDI track that contains the data you want
to send to Receptor.
3 Open the editor for that UniWire˛Instrument and tell it where, on Receptor, you want to route this MIDI data.
Following through with the previous example, this would be Receptor Channel 1, since it contains the Minimonsta
instantiation you wish to play.
Audio/MIDI from Receptor and Your Computer Are Used Simultaneously
In this scenario, both Receptor’s audio and MIDI connections and your computer’s audio and MIDI connections
are used simultaneously. To do this, you must rst turn on UniWire and enable Receptor to use its own
Audio+MIDI ports in conjunction with UniWire:
1 Connect audio and MIDI cables to Receptor and to your host computer’s audio/midi interfaces.
2 Connect a crossover Ethernet cable between Receptor and your host computer or, if using multiple
Ethernet devices, connect a standard Ethernet cable between Receptor and your host computer’s Ethernet
Router/Switcher.
3 On Receptor, make sure UniWire mode is turned on.
On the front panel, press the SETUP button, rotate the top display knob to select the UniWire option, then rotate the
bottom display knob to select Enabled.
On the graphical interface, press the Setup Tab and, in the UniWire section, check the Enable UniWire option.
4 Enable Receptor’s built-in Audio + MIDI I/O.
On the front panel, press the SETUP button, rotate the top display knob to select the UniWire Receptr I/O
option, then rotate the bottom display knob to select Audio+MIDI Enabled.
On the graphical interface, Press the Setup Tab and, in the UniWire section, check the Enable Receptor Audio+MIDI
I/O option.