Manual

UniWire Manual Supplement 26 Muse Research, Inc.
Cubase Uses Receptor as an External UniWire Instrument
The following describes how to use UniWire to make Receptor act as an external instrument within
Cubase˛SX3:
1 Before beginning, make sure UniWire is enabled on Receptor.
To do this from Receptor’s graphical interface, click the SETUP tab and check the Enable UniWire option in the new
UNIWIRE section in Setup View.
To do this from Receptor’s front panel, press the SETUP button and rotate the top display knob until the top line shows
the “UniWire” option, then rotate the bottom knob to select Enabled.
2 In Cubase, create a new MIDI Track by choosing Project>Add Track>MIDI.
3 Choose Devices>VST Instrument and, in a blank instrument selector within the resulting window, choose
UniWire Instrument from the Muse folder.
4 In Cubase’s Track Inspector, assign the desired MIDI Input to this track; assign the previously instantiated
UniWire Instrument plugin as the MIDI out, and set a MIDI channel.
UniWire VST Instrument Assigned
Click to open UniWire plugin
MIDI Channel
5 Click the “Open Device” icon (to the left of the MIDI channel setting) to open the graphical editor for the
UniWire plugin.