music hall mmf-1.3 INSTRUCTION MANUAL music hall http://www.musichallaudio.
IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. Read these instructions carefully. Keep these instructions for later reference. Heed all warnings. Follow all instructions. Do not use the device near water. Clean only with a dry cloth. Do not block any ventilation openings. Always ensure a sufficient ventilation. Install in accordance with the manufacturer’s instructions. 8.
SETUP and ASSEMBLY Some assembly is required before you can begin to use your new unit. Please follow the assembly instruction below before attempting to use your new turntable. NOTE: Do not connect your turntable to a power outlet with the AC adaptor until you are finished with assembly. Do not remove the twist tie for clamping the tone arm until assembly is completed. PRECAUTIONS ON PLACEMENT: 1.
PART NAMES and FUNCTIONS FRONT & REAR PANEL 6 6 1 2 3 5 4 7 8 9 10 11 12 1. Platter Place the platter on the spindle while you are assembling your turntable. It has a drive belt wound around on the back side. 2. Rubber Mat 3. Spindle 4. SPEED/POWER rotary switch knob Rotate the knob to turn on/off your turntable or select the rotation speed appropriate to the vinyl record to play. 5. Tone arm part For details, refer to “Tone arm” paragraph. 6.
PART NAMES and FUNCTIONS TONEARM 1. Counterweight Balances the tone arm and adjusts to provide the proper tracking force. 5 1 2 2. Tracking force gauge ring Use to adjust the tracking force 3. Tone arm lift Moves the tone arm vertically to and from the face of the record. 3 4. Tone arm rest 6 4 7 5. Anti-skate control dial While the record is playing, a force acts on the stylus tip to pull it inward. This force can be counteracted by setting the same values for anti-skate and the tracking force. 6.
PLAYING A RECORD Before you play a record, turn down the volume of the connected audio device (an amplifier, speakers, etc.) to avoid a possible loud crackling noise. The crackling noise made by the stylus coming into contact with the vinyl record could damage the audio device. Wait until the stylus is completely placed on the vinyl record, and then turn up the volume. 1. Place a record onto the platter. NOTE: Place only one vinyl record on the platter at a time.
SPECIFICATION 1. GENERAL SECTION Power Supply Dimensions Consumption Weight 2. TURNTABLE SECTION Type Motor Driving Method Turntable Platter Speeds Wow and Flutter S/N Ratio Speed Tolerance 3. CARTRIDGE SECTION Type Stylus Height of Arm Lifter Channel Separation Channel Balance Phono Output Level Line Output RIAA DC12V炻2.0A 17.1(W) x 14.5(D) x 4.2(H) in. 4W 11lbs. 5Kg 435(W) x 367(D) x 106(H) mm 3-speed full manual DC motor Belt drive 296mm dia.
WARRANTY This entitles you to have the music hall mmf-1.3 repaired free of charge, at our discretion, for one year after the date of purchase, at any authorized Music Hall Service Center, provided the unit was purchased from an authorized dealer. Your original sales receipt is proof of purchase date. Music Hall takes no responsibility for defects arising from accident, misuse, abuse, wear and tear, neglect or unauthorized repair and/or adjustment.
