Owner's Manual

14
turntable is not working properly, please take a few moments to review this list of
potential causes.
THE PLATTER DOESN'T TURN, ALTHOUGH THE DECK IS SWITCHED ON:
• The turntable is not connected to the mains power supply.
• No mains at the socket.
• The belt is not fitted or has slipped off.
NO SIGNAL IN ONE OR BOTH CHANNELS:
• No connection between the turntable and amplifier.
• Phono input not selected at amplifier.
• Poor contact or broken connection.
• Amplifier not switched on.
• Amplifier or speakers defective or muted.
• Cartridge not wired into the head shell
• Loudspeakers not connected.
LOUD HUM ON PHONO INPUT:
• No earth connection from cartridge, tonearm, or audio cable to amplifier.
• Ground loop.
• Turntable too close to one or both speakers.
DISTORTED SOUND FROM ONE OR BOTH CHANNELS:
• Record player connected to wrong input of amplifier.
• MM/MC switch on pre-amp incorrectly set.
• Dust on the stylus.
• Needle or cantilever damaged.
• Wrong speed
• Dirty or over-stretched belt.
• Platter bearing dry, dirty, or damaged.
SERVICE
Should you encounter a problem that you cannot solve, please contact your
music hall dealer. Never return a record player without authorization and without