Owner's Manual

9
playing time) feel free to experiment with a slightly higher or lower tracking
force and pick the one you prefer.
12. Locate the anti-skating weight (16). You will notice a small fishing line
attached to the anti-skating weight (16). Slip the looped end of the fishing line
over the anti-skating rod (15) and into notch number 2 (See diagram below).
Lift the anti-skating weight (16) over the anti-skating hanger (17) and feed the
fishing string through the looped end of the anti-skating hanger (17). The
anti-skating weight (16) should now be dangling in free space to the left of the
hanger. If it is not dangling, simply bend the anti-skating hanger (17) by
pushing it away from the tonearm pillar with your finger.
13. Slide the dust cover (10) onto the dust cover hinges (11) on the back of the
plinth. If necessary, adjust the tightness of the hinges by turning the dust
cover hinge screws (12).
NOTE
If you are substituting another cartridge for supplied one, you may need to make
the following further adjustments to the tonearm (9) and cartridge:
If you are a novice, music hall recommends getting professional help.
All cartridges with half inch mounting holes can be fitted. Leaving the stylus guard
on, fit the cartridge to the head shell (21) using the screws supplied with the
cartridge by passing one screw through each slot in the finger lift and the head
shell (21). Snug the nuts.
Connect the tonearm (9) wires to the cartridge pins as follows:
white left channel positive (L+)
red right channel pos. (R+)