Owner's Manual

SET-UP
The music hall mmf-7.1 is supplied partially disassembled and carefully packaged for
safe transport. To assemble the turntable, please follow the instructions carefully.
1. Clear a level (use a spirit level) and suitable workspace to assemble the turntable.
This may be the final playing location.
2. Remove and put on white cotton gloves (in large plastic bag)
3. Remove the turntable and all parts from the carton. A short gray piece of plastic
pipe will be found underneath the cutout portion of the turntable on top of the motor.
This is part of the packing and is not used with the motor or turntable.
4. Screw the three spiked feet (25) (included in parts bag) onto the threaded screws
(23) on the bottom of the turntable. 4 x spike protectors (26) (flat dime looking
objects that spike sits on) are included. Use them underneath the spikes.
5. Level the turntable by adjusting the spiked feet (25). Use the bubble level (24) for
this purpose.
6. Remove the 3 transport screws (1) from the turntable and save for future use.
7. Gather together the 3 motor components (round motor base – found in bottom of
box under the Styrofoam, wall transformer – found in small white carton in bottom of
box, and motor – found underneath the turntable motor cutout and piece of gray
plastic pipe. The short plastic gray pipe is part of the packing material and is not
used with the turntable or motor.
8. Place the round motor base underneath the motor cutout on the left front of the
turntable. Center the motor base in the cutout.
9. Carefully, ease the motor into the cutout and onto the motor base. Orient the motor
so that the socket for connection to the wall transformer is towards the back.
10. Run wire from the wall transformer under the turntable and plug it into the socket on
the lower back of the motor.
11. Center the platter (5) over the spindle of the sub-platter (4) and lower it until it rests
securely on the sub-platter.
12. Install the drive belt (3) for 33⅓ rpm play. Loop the belt around the smaller diameter
rim of the stepped motor pulley (2) and around the rim of the platter (5). (For 45rpm
play, use the large diameter rim of the motor pulley).