Specifications

INTRODUCTION
Thank you for your purchase of the Bellari VP130 Tube Phono Preamp.
The VP130 is designed to amplify an RIAA equalized phono signal to a
Hi-Fi level signal, and is intended for magnetic pickups. Since the unit
utilizes tube circuitry, the resulting output signal is more warm and
musical than solid state preamplifi ers.
INSPECTION
1. Unpack and Inspect the VP130 package
Your VP130 was carefully packed at the factory in a protective carton.
Nonetheless, be sure to examine the unit and the carton for any signs
of damage that may have occurred during shipping. If obvious physical
damage is noticed, contact the carrier immediately to make a damage
claim. We suggest saving the shipping carton and packing materials
for safely transporting the unit in the future.
2. We recommend registering on-line at www.rolls.
com.
DESCRIPTION
GROUND CONNECTOR: Connects to the Ground of the phonograph.
INPUT: Stereo RCA jacks for connection to the phonograph.
OUTPUT: Stereo RCA jacks for connection to a stereo system or ampli-
fi er.
STEREO HEADPHONE/LINE OUTPUT: 1/4" Tip-Ring-Sleeve jack for con-
nection to any standard pair of headphones or earphones.
PWR INPUT: 15V DC 700mA.
RUMBLE FILTER: High pass fi lter - eliminates frequencies under 20Hz.
MUTE: When pressed in - mutes the RCA outputs. The Headphone Out-
put will still have signal present.
OUTPUT LEVEL: Adjusts the amount of signal to the RCA Outputs.
HEADPHONE LEVEL: Adjusts the amount of signal to the Headphone/
Line Output.
To amplifier or recorder
15v DC
700 mA
CONNECTION/OPERATION
Connect your turntable to the VP130 as shown. The Outputs may be
connected to an amplifi er or recording device such as; a cassette re-
corder, computer sound-card, or tuner Aux input. Only use a Tip-Ring-
Sleeve stereo plug in the Headphone Output. CONNECTING A MONO
PLUG IN THIS JACK MAY RESULT IN DAMAGE TO THE VP130.
Connect the power adapter to the unit and an AC outlet or power
strip.
Play a record on the turntable and adjust the Output Level and Head-
phone Level controls to the desired amounts.
Switch in the Rumble Filter to eliminate very low frequencies if needed.
Press in the Mute switch when you wish to mute the RCA outputs of
the VP130 (the Headphone Output will still be active).
VERY IMPORTANT NOTES:
First of all - turntables and tube equipment have a certain level of
noise. That's why the two technologies are essentially obsolete.
The VP130 is intended for use with Moving Magnet cartridges, not
Moving Coil. While a Moving Coil cartridge will work, you will be
required to turn up the volume of the unit as well as your receiver/
amplifi er causing an increase in noise.