Specifications

TiTAN
GENERAL ADVICE
Issue 1
Page 4 of 12
INSTALLATION PRECAUTIONS and USER INFORMATION
The TiTAN is designed and built to provide trouble-free performance, but as with all electronic devices it is
necessary to observe a few precautions:
Heed all warnings shown on the back of the product.
Only connect the TiTAN to a mains outlet having the same voltage as marked at the back of the unit.
Always ensure that when disconnecting and reconnecting audio equipment the mains supply is
switched off.
Position the mains lead and signal interconnects where they are not likely to be walked on or trapped
by items placed on them.
This unit features a BRIDGED speaker output and should NOT be grounded on either speaker output
terminal as both terminals are effectively “hot”, i.e. carry signal. Please check if using any active
“sub”, electrostatic, or other non standard potentially grounded speaker types directly connected to the
outputs of the TiTAN. Consult speaker manual or supplier if in doubt.
Do not use near water, or place water-filled containers on the TiTAN, for example, a flower vase or
potted plants. If water does spill inside, immediately pull out the mains plug from the wall
socket and inform the dealer, who should then check the unit before further use. Entry of
liquid into the TiTAN is dangerous, and may cause electric shock or fire hazard.
Do not place the unit near direct heat sources such as radiators, direct sunlight or other equipment.
Do not remove any covers or try to gain access to the inside. There are no user-serviceable internal
adjustments . Refer all service work to an authorised Musical Fidelity agent.
Note: Unauthorised opening of the equipment will invalidate any warranty claim.
Dust regularly with a soft cloth or soft brush but be careful when using cleaning or polishing agents - they
may harm the surface finish.
The electronics in modern hi-fi equipment is complex and may, therefore, be adversely affected or damaged
by lightning. For protection of your audio system during electrical storms, remove the mains plugs and
disconnect any aerial lead.
If after-sales service is required, to help the dealer identify the TiTAN please quote the serial number located
on the rear panel of the unit.