Specifications

Issue 4 Page 14 of 17
PLAY 1
0
:
41
program play
PLAY 1
0
:
41
program rpt
If at any time you wish to add a track to the list, press the CLEAR button to obtain the next step number.
Alternatively, to delete a previous entry, press CLEAR a second time to remove the last entry. Repeated
pressing of CLEAR will then erase each step in reverse order. So to delete an entire program sequence from
the memory, press CLEAR repeatedly until “PROGRAM 1” is shown in the display.
When the last track number has been entered, press PROGRAM a final time, then the
►|▐▐ button to start the
program sequence.
If you wish to check the selection before playing back your program, the CHECK button can be pressed to step
through each program entry in turn.
If during this check sequence the
►|▐▐ button is pressed, the remaining part of your programmed selection will
play to the end of the sequence.
Otherwise, to play all the programmed tracks from the beginning of the sequence, press
►|▐▐, or ► on the
remote control directly from programming. You can also start the sequence from any point by stepping through
the programmed sequence with CHECK button until the desired starting track is displayed.
The
►►| button may be pressed to jump to the next track in the programmed sequence, or |◄◄ button to obtain
the previous track in the sequence.
When all programmed tracks have played, the CD player stops. The same track selection can then be played
again by pressing the
►|▐▐ button on the front panel, or ► on the remote control.
To repeat a programmed sequence continually, press REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note: The program contents will be cleared if you switch off the power, or load another disc. If,
however, the same disc is loaded again with the power still switched on, the program sequence is
retained in the memory.
TIME (remote control only)
Pressing the TIME button displays the word TRACK followed by the current track elapsed time. Pressing a
second time displays the word DISC then the total disk time elapsed.
Trigger input and output
The unit can be triggered to switch on or off remotely by applying a ±4.5 to ±15V DC signal to the 3.5mm (⅛”)
TRIGGER INPUT from an external triggering device.
Any further devices to be triggered on/off may be connected to the TRIGGER OUTPUT jack as it replicates the
TRIGGER INPUT signal. This will form a chain of devices that will switch on and off together.
N.B. the on/off triggering action works from ANY device in the chain, whether at the beginning, middle or end of
the chain.
Standby after 1 hour
In order to comply with EU directives, an automatic standby feature has been introduced to the M1 CDT.
If not used for over approx. 1 hour, the unit will revert to STANDBY mode of its own accord.
This is normal behaviour and to use the unit once more, simply press the STANDBY button on the front panel or
remote control.
Devices connected to TRIGGER IN or OUT will still function as mentioned above under “Trigger input and
output”.
OPERATION