Owners Manual

M3SCD issue 1 Page 14 of 20
PLAY 1
0
:
41
program play
PLAY
1
0
:
41
program rpt
If at any time you wish to add a track to the list, press the CLEAR button to obtain the next step number.
Alternatively, to delete a previous entry, press CLEAR a second time to remove the last entry. Repeated
pressing of CLEAR will then erase each step in reverse order. So to delete an entire program sequence from
the memory, press CLEAR repeatedly until “PROGRAM 1” is shown in the display.
When the last track number has been entered, press PROGRAM a final time, then the
►|▐▐ button to start the
program sequence.
If you wish to check the selection before playing back your program, the CHECK button can be pressed to step
through each program entry in turn.
If during this check sequence the
►|▐▐ button is pressed, the remaining part of your programmed selection will
play to the end of the sequence.
Otherwise, to play all the programmed tracks from the beginning of the sequence, press
►|▐▐, or ► on the
remote control directly from programming. You can also start the sequence from any point by stepping through
the programmed sequence with CHECK button until the desired starting track is displayed.
The
►►| button may be pressed to jump to the next track in the programmed sequence, or |◄◄ button to obtain
the previous track in the sequence.
When all programmed tracks have played, the CD player stops. The same track selection can then be played
again by pressing the
►|▐▐ button on the front panel, or ► on the remote control.
To repeat a programmed sequence continually, press REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note: The program contents will be cleared if you switch off the power, or load another disc. If,
however, the same disc is loaded again with the power still switched on, the program sequence is
retained in the memory.
TIME (remote control only)
Pressing the TIME button displays the word TRACK followed by the current track elapsed time. Pressing a
second time displays the word DISC then the total disk time elapsed.
DISPLAY (remote control only)
The CD display brightness can be controlled in three levels and switched off, by pressing the DISPLAY button
on the remote control.
The original setting is maximum brightness, but by pressing the DISPLAY button repeatedly, brightness is
reduced, display off.
CD notes:
We advise caution with using cheap and/or computer type CD-R/RW disks for audio. To ensure optimum
reliability and performance we recommend all home-generated CDs intended for playback on this unit are
recorded as CDDA AUDIO CDs (the unit does not playback MP3, WAV, encoded disks) on good quality
household brand AUDIO type CD-R/RWs; and burned at a slower speed, say, 16x.
Remember - the most vulnerable part of a CD playing system is the disc itself. The most likely cause of a disc
not playing is that the disc itself is faulty, scratched or simply dirty. Never open the case of the unit yourself, as
this will invalidate the guarantee. If none of the above actions affect a cure, please contact your dealer or
Musical Fidelity service agent.
OPERATION