Owners Manual

Installation

Introduction

This unit will deliver the ultimate performance

possible from any phono source

Cleaning

Before cleaning the unit, switch off power at the

mains switch and remove the mains plug from the

wall socket

Clean the cabinet and remote-control

unit using a moist cloth

Using solvents, white

spirit or thinners is not advised, as they could

damage the surface finish.

Installation

Position the M3x ViNYL on a stable, horizontal

surface where there is no risk of it being

knocked or subjected to vibration such as from

loudspeakers

Power Connections

The M3x ViNYL is supplied with a standard IEC

mains cable which plugs into the IEC socket at the

back of the unit

Audio Output Connections

RCA audio output: Use good quality RCA phono

audio cables (fully connected signal and ground),

for optimum signal transfer

Interconnects

If necessary, please refer to the dealer who can

advise on quality cables for any setup. Musical

Fidelity does not endorse any other

manufacturer’s cables

Cartridge characteristics

For setting the various loading characteristics, the

cartridge manufacturer’s data sheets or setup

information should be consulted

In a lot of cases the settings are not critical, and

may even be changed to suit personal preference,

if any audible differences are apparent.

No damage will occur to an “incorrectly” loaded

cartridge; at very worse a slightly impaired or

nonoptimal frequency response and/or slightly

increased distortion, both most likely to be

inaudible, may result