Owners Manual
MM / MC
PHONO STAGE
x ViNYL
8
Troubleshooting
Problem
Probable Cause
Remedy
No power
.
Power plug is not inserted into
socket correctly
.
Plug in securely into unit’s IEC socket
.
No sound
.
Wrong connections between
input sources and the unit
Cartridge incorrectly wired
.
Check audio input and output lead connections
.
Check cartridge wiring
.
Sound too quiet/loud.
Wrong MM/MC cartridge
selection
.
Use MM setting for MM cartridges
.
Use MC setting for MC cartridges
.
Sound is not precise,
lacking in bass and
stereo image
.
Cartridge incorrectly wired
.
Input connector plugs not fully
pushed in
.
Output connector plugs not fully
pushed in
.
Check turntable tracking weight and cartridge setup
.
Check plugs are inserted fully and securely
.
Hum.
Turntable not earthed or needs
earthing.
Turntable already earthed and
earthing
further creates hum loop in
system
.
Earth loops already in system
being amplified.
Audio connector plug not fully
pushed in
Cable fault
.
Unsuitable Cable
(e .g
.
cable grounds not
connected)
.
Check turntable earthing lead is connected to earthing post
.
Disconnect earthing lead from earthing post
.
Investigate for earth loops elsewhere in system
.
Insert plug securely and check cable is connected at both ends
.
N .B
.
some esoteric cables have internal wiring intentionally disconnected/
modified. For best results on all inputs AND outputs, please use good
quality screened coax; fully connected signal-to signal, screen-to-screen.
Pop or click heard in
speakers
when switching on or
off or
changing options
.
High gain of M3x
ViNYL, amplifying
normal circuit
transients
.
Not a fault. It is recommended that the volume level on amplifier is turned
down if switching the M3x ViNYL on or off; or pressing option switches
whilst connected
.
Distorted sound
.
Cartridge and/or tone arm not
aligned properly
.
Cartridge fault or worn needle
.
Dirt on record
.
Carefully follow turntable instructions to correctly re-align tone arm and
cartridge
.
Replace needle or cartridge
.
Clean dust and dirt from record
.
Distorted and loud
sound
.
Line outputs of M3x ViNYL
plugged into PHONO amplifier
inputs of following amplifier.
Use LINE level inputs only, e.g. an AUX input.
If none of these actions affect a cure, please contact the dealer, or an authorised Musical Fidelity
service agent
.
Remember; never open the case of the M3x ViNYL, as this will invalidate the warranty
.