Instruction Manual

Page1of3
Mounting Suggestions
Harley-Davidson® FLHT, FLHX, FLTR, FLHR 2009-13
Cyclone Solo Seat and Frame Mounting Plate
Installthe2”longboltthr
ough
thefrontmountingbracket
(carpetside).Placethe3/4”
longboltswithwashers
throughtheframemounting
plate’scenterholes,hold
theminplacewiththerubber
washers.
HardwareIncluded:
(2)ChromeWashers (1)¾”PlasticSpacers
(2)ChromeAcornNuts (1)1/2”PlasticSpacers
(2)BlackRubberWashers (2)HexBolts¼”‐20x3/4”Long
(1)HexBolt¼‐20x2”Long (2)FlatWasher1/4”
Fliptheframemountingplate
over,placebothplasticspacers
ontothefront2”bolt.Now
threadthefrontboltintothe2nd
holeinthefrontoftheCyclone
Soloseat,butdonottighten.
Alignthetworear3/4”boltswith
theseat’srearthreadedinserts.
Tightenallthreebo
ltswitha
7/16”wrench.
The Cyclone Solo seat can be positioned 1” further back on the frame mounting plate
by drilling the two indented marks in the frame mounting plate with a 5/16” drill.