Manual

Installation Instructions:
Wrap-Around Passenger Backrest
for 1986-2013 King TourPak
Step 1 Open King TourPak lid; locate and remove
six hex nuts holding stock wrap-around unit in place.
Step 2 Remove wrap-around unit from King Tour-
Pak lid.
Step 3 Note locations of all six holes in King Tour-
Pak lid. Mustang wrap-around unit uses three holes
only; the two outermost holes, and the lower center
hole, using supplied hardware for a secure installa-
tion .
Step 4 Remove all supplied hardware from the three
mounting studs on the back of the Mustang wrap-
around unit.
Step 5 Prepare Mustang wrap-around unit for instal-
lation by placing one rubber washer onto each of the
three mounting studs.
Step 6 Align the three mounting studs with the two
outermost holes and the lower center hole in the tour-
pak lid; push all three studs through the holes. Place
one rubber washer onto each stud, followed by one
metal washer and one hex nut. Tighten all for a se-
cure installation.
Note: All three mounting studs are adjustable for
help in aligning them with holes in TourPak lid. When
the L-studs are in the up position, they will fit 1999
and earlier TourPaks. In the down position the L-
studs will fit 2000 and later TourPaks
Step 7 Cover the three un-used mounting holes in
the lid with the provided stick-on rubber pads.
These steps are guidelines to help you install your new Mustang product. If you need
further assistance please call us at 800-243-1392, Monday through Friday 9:00 - 5:30
Eastern or send an e-mail to [e-mail] or visit our website
at www.mustangseats.com.
For care and maintenance of our products, please go to our website under "Support".
Ref: part #'s 75306, 75317, 75324, 75330, 75331, 75332
Stick-on
rubber pads
Two rubber washers, one metal washer,
one hex nut, for each mounting stud.
Back view of wrap-around