Owner's manual

Installation Instructions for Mustang

Fender Bib

on 2011 Yamaha Stryker

These steps are guidelines to help you install your new Mustang product. If you need

further assistance please call us at 800-243-1392, Monday through Friday 9:00 - 5:30

Eastern or send an e-mail to questions@mustangseats.com or visit our website

at www.mustangseats.com.

For care and maintenance of our seats, please go to our website under "Support".

Ref. part #’s 78140, 78141

1. Remove center mounting bracket and U-bracket

from rear fender.

2. Install Mustang’s solo seat mounting bracket as

shown, leaving the two button head screws loose.

3. Align the two holes at the back end of the bib with

the holes in the rear fender and insert two sup-

plied button head screws. Tighten.

4. Pull bib forward under front bracket for a snug fit,

then tighten the two screws to secure bracket and

bib to fender.

5. Enjoy the custom look of your new Mustang

fender bib.

PAGE 1
Installation Instructions for Mustang Fender Bib on 2011 Yamaha Stryker 1. Remove center mounting bracket and U-bracket from rear fender. 2. Install Mustang’s solo seat mounting bracket as shown, leaving the two button head screws loose. 3. Align the two holes at the back end of the bib with the holes in the rear fender and insert two supplied button head screws. Tighten. 4. Pull bib forward under front bracket for a snug fit, then tighten the two screws to secure bracket and bib to fender. 5.