User guide

Installation Instructions

Heated Touring One-Piece

HD FL touring models

Step 1 Remove the stock seat from the motorcy-

cle.

Step 2 Locate the accessory receptacle,

part #72164-94, usually found in front of the bat-

tery as shown. If this unit is already in use, a dual-

port accessory receptacle, part #70264-94A, must

be installed before proceeding with the Mustang

seat installation.

Step 3 Remove the rubber cap from the acces-

sory receptacle. Make sure that the receptacle is

clean and free of any dirt or debris.

If dirty, be sure to clean it before attaching heating

plug from Mustang seat.

Step 4 Prepare seat for installation. Make sure

that the plug for the heating element is clean

and free of any packing material. Check to see

that the electrical wire is free of kinks or sharp

folds. Check both switches for ease of opera-

tion; center position is off; top position is high;

bottom position is low.

1997-2013

PAGE 1
Installation Instructions Heated Touring One-Piece HD FL touring models 1997-2013 Step 1 Remove the stock seat from the motorcycle. Step 2 Locate the accessory receptacle, part #72164-94, usually found in front of the battery as shown. If this unit is already in use, a dualport accessory receptacle, part #70264-94A, must be installed before proceeding with the Mustang seat installation. Step 3 Remove the rubber cap from the accessory receptacle.
PAGE 2
Installation Instructions for Mustang One-Piece Heated Touring Seats on 1997-2013 HD FL touring models Step 5 Insert plug from Mustang seat into receptacle. Make sure connection is secure. An audible click should be heard when plug is fully engaged. Step 6 Check to make sure there are no folds or kinks in the wire leading from seat to receptacle before finalizing installation of seat. Engage front mounting tab first, push seat all the way forward, and insert and tighten the rear fender screw.