Installation guide

P/N: 4809654 v5.0

Q. MAF Interface Adapter (MAFia) Installation

(H.O. kits only)

1. Locate the MAFia box.

2. Plug the MAFia between the factory MAF

connector and the MAF sensor.

3. Remove the small red cover in the middle

of the supplied MAFia box.

4. Verify that the MAFia box is set on num-

ber “2”.

5. If you find that the MAFia box in not set,

use the tool that is provided with the

MAFia box and set to number “2”.

6. Replace the cover and secure the MAFia

box away from hot or moving parts with

nylon ties.

7. An ideal location for mounting the MAFia

box is on the shock tower secured with

wire ties or double sided tape.

*** NOTE ***

It is critical that the MAFia box be set on number “2”,

The calibration that is provided with this kit has been

created to work at this setting. Any change to the

MAFia box by setting it to a higher or lower number

could cause damage to the engine.

12. AIR INLET ASSEMBLY, cont’d