Manualshelf

Instructions / Assembly

ManualsBrandsMUSTEE ManualsPlumbing17 in. x 20 in. Fiberglass Self-Rimming Utility Sink in Bone
1234
E.L. MUSTEE & SONS, INC.
5431 West 164th Street • Brook Park, Ohio 44142
4
MUSTEE
HOSPITALITY SINK
“SELF RIMMING — COUNTERTOP MOUNTED”
MODEL 11
P
ARTS ILLUSTRATION
* NOTE: FOR REPLACEMENT HARDWARE, ORDER COMPLETE PARTS PACKAGE
PART NO. 10.606 — PACKAGES WILL NOT BE SPLIT FOR INDIVIDUAL PARTS.
WHITE BONE
1 11.101 11.102 Self Rimming Sink
2* * Mounting Stud (4 Required)
3* * Mounting Plate (4 Required)
4* * Mounting Nut (4 Required)
PART NUMBER
PARTS LIST
DESCRIPTION
KEY
NO.
SI-166 (6•06)
Your Hospitality Sink requires a 15 1/2” x 18 1/2” countertop cutout. Refer to Rough-In for detail dimensions.
NOTE: The centerline of the drain is located 11” from the back edge and 8 1/2” from either side. If you choose, you
may use your Hospitality Sink as a template for laying out the countertop cutout. Measure actual part before drilling
or cutting countertop.
CARE AND CLEANING
The surface of your Self-Rimming Countertop Sink may be cleaned with a mild soap in warm water using a soft
cloth. For stubborn stains use “Soft-Scrub” by Clorox or Lysol “Tub & Tile Cleaner” or a powdered detergent such
as “Spic-n-Span.” Never use abrasive scouring powder or steel wool pads as they will dull the surface. A periodic
coating of a silicone based marine polish will help retain the fine finish.
ROUGH-IN DIMENSIONS
SI-166 (6•06)
E.L. MUSTEE & SONS, INC.
5431 West 164th Street • Brook Park, Ohio 44142
LISTED
FILE NO. 820
MUSTEE
HOSPITALITY SINK
MODEL 11
1. Place Hospitality Sink (1) upside down on countertop in desired location — hold sink in place and scribe a guide
line all around the rim with a pencil.
HINT:
If pencil does not mark surface of countertop, you may apply 2” wide masking tape to the approximate area and
do the marking directly on the tape surface. Leave tape in place to protect countertop surface during drilling
and cutting.
2. Remove Hospitality Sink, measure in 3/4” from guide line all around; this will be your cutting line. Measure in
3/4” in each corner; this will be the center point for the 7/8” diameter hole — 4 required. Insert (fine tooth) sabre
saw blade into one of the corner holes and cut along “Cutout line.” — See “Countertop Cutout Details”
* NOTE:
DIMENSIONS SHOWN ARE NOMINAL,
MEASURE ACTUAL PARTS BEFORE
DRILLING/CUTTING COUNTERTOP.

Summary of content (4 pages)