Instructions / Assembly

TYPICAL STUD INSTALLATION

SI-166 (6•06)

3. The rear ledge of your Hospitality Sink will accept many different faucets; 4” Center Set on center, 4” Center Set

either right or left, 8” Center Set on center. Depending on the model faucet you choose, the appropriate holes will

have to be drilled. You will notice that there are five indented hole locators molded-in, on the underside of the rear

ledge, do not cut out faucet holes until you have measured the actual faucet you intend to use — some single

lever faucets require a large center/supply hole and small diameter mounting holes. A 1” diameter, fine tooth hole

saw with center drill pilot would normally be used for the majority of faucet hole drilling. Drill from underside of

rear ledge to mark center, turn upright to finish cutting with hole saw.

4. Install “Basket” Style Drain Assembly per manufacturer’s instructions. The Hospitality Sink is furnished with a

3 1/2” diameter drain hole.

5. Install Mounting Studs (2) in each corner lug — CAUTION — DO NOT OVERTIGHTEN!! A standard 5/16” socket

or wrench is required. Screw stud in place until nut makes contact with bottom of lug — continue 1/4 turn,

maximum. Repeat this operation for each mounting lug. — See “TYPICAL STUD INSTALLATION”

6. Apply a bead of clear siliconized sealant* (not furnished) all around the underside of the rim in the molded-in

groove — See Detail Drawing. Place Hospitality Sink into the countertop cutout, secure from the underside with

hardware provided. You will need a 7/16” socket or wrench to secure

Mounting Nuts (4) in place. Wipe away any excess sealant that squeezes

out during tightening. — See “CAULKING / SEALANT DETAIL”

7. Complete water supply and proper sanitary waste trap connections as specified by local code requirements.

Numbers in ( ) parantheses refer to Key Numbers in Parts List.

APPLY A BEAD OF SILICONIZED

SEALANT* APPROXIMATELY 3/8”

DIA. — THIS AREA, AROUND

UNDERSIDE OF RIM.

*Siliconized Sealant such as:

CELULON™ Plumbing & HVAC

Adhesive Sealant by Red Devil

CAULKING/SEALANT

INDENTED HOLES ON UNDERSIDE OF

REAR LEDGE TO BE DRILLED OUT BY

CUSTOMER TO ACCEPT EITHER 4” OR

8” SUPPLY CENTER FAUCETS

FAUCET HOLE DET

AIL

HINT:

APPLY A DAB OF SILICONIZED

SEALANT TO THREADS TO

LUBRICATE STUD AND EASE

INSTALLATION.

COUNTERT

OP CUTOUT DETAILS

SI-166 (6•06)

SINK OUTLINE — DO NOT

CUT ON THIS LINE!!