Installation Guide

ManualsBrandsMustee ManualsShower Doors32.706

TRIDENT (residential)_03/08/99

TELEPHONE NO.

(904) 642-3970

Coastal Industries Inc.

P.O BOX 16091

JACKSONVILLE FLORIDA 32245

TRIDENT

(Residential Series)

ADJUSTABLE PIVOT SHOWER DOOR

INSTALLATION INSTRUCTIONS

DESCRIPTION

SILL ....................................................................

STRIKE JAMB....................................................

DOOR ASSEMBLY..............................................

PIVOT JAMB.......................................................

PIVOT PLATES...................................................

PLASTIC SCREW ANCHOR .............................

HEX NUTS (INSTALLED)...................................

WASHERS (INSTALLED)...................................

DOOR T-BOLT SCREWS (INSTALLED)............

TOP & BOTTOM PIVOT BUSHING ...................

PIVOT PLATE SCREWS....................................

MAGNET STRIP ................................................

EXPANDER JAMB .............................................

PIVOT JAMB INSTALLATION SCREWS............

STRIKE JAMB ADJUSTMENT SCREWS ..........

DOOR VINYL SWEEP .......................................

EXPANDER JAMB INSTL SCREWS..................

QUANTITY

PARTS LIST

TOOLS NEEDED

LEVEL ELECTRIC DRILL MEASURING TAPE

HACKSAW 3/16" MASONRY DRILL BIT 7/16" OPEN END WRENCH

HAMMER SAFETY GLASSES CLEAR CAULKING OR SEALANT

CENTER PUNCH PHILLIPS SCREW DRIVER (MILDEW RESISTANT)

MASKING TAPE PENCIL / FELT TIP PEN

FAX NO.

(904) 641-1697

PART

NUMBER

310

148

----

796

1329

1428N

1428W

1428B

18712A

834F

98-42

147

82P

638PHPT

C171G

8112

KEY

LETTER

Summary of content (4 pages)

PAGE 1
Coastal Industries Inc. FAX NO. (904) 641-1697 TELEPHONE NO. (904) 642-3970 P.
PAGE 2
Unit Installation Screws (shown full size as reference) TRIDENT (Residential Series) (EXPLODED VIEW - OUTSIDE OF UNIT LOOKING IN ) (RIGHT HAND PIVOT SHOWN) 2
PAGE 3
1 Measure base opening & trim Sill 4 Install Pivot Bushings Measure the base opening along the lead edge of the shower curb as shown. Using a hacksaw . . . trim Sill (A) to the measurement obtained. Insert the bottom Pivot Bushing (K) into bottom Pivot Plate (E) as shown in figure. Make sure that "Y" portion of pivot bushing is straddling the Pivot Jamb (D). Insert the top Pivot Bushing (K) into the top Pivot Plate (E) as shown in the exploded view, front sht.
PAGE 4
7 Install Door Assembly 9 (continued) Close Door Assembly (C) and slide it toward Strike Jamb (B) as shown below. Next, adjust the Strike Jamb (B) until it is parallel to the Door Assembly strike edge as shown. Do not secure at this time. Before proceeding, take a minute to loosen the Door Assembly's top and bottom Hex Nut (G), making sure they are only finger tight. Set door in position by placing bottom T-Bolt (J) into bottom Pivot Bushing (K).