Installation Guide

Model:
390
SERIES
CareGiver
®
Fold-Down Padded Seats
READ ALL INSTRUCTIONS CAREFULLY AND INSPECT PRODUCT FOR DAMAGE BEFORE STARTING YOUR INSTALLATION.
Right-hand seat — wall mount
390.401 style
Left-hand seat — wall mount
390.402 style
Rectangular seat — wall mount
390.409 or 390.413 style
INCLUDED IN CARTON:
One (1) seat assembly with two wall brackets (attached)
One (1) middle support “slide” bracket
One (1) template for mounting
TOOLS AND MATERIALS FOR INSTALLATION:
Drill – electric or cordless Eight (8)
1
/
4
" x 3" stainless steel lag screws
3
/
16
" and
1
/
4
" drill bits
Mounting hardware not supplied due to variations in wall
backing. Use appropriate fasteners as recommended
by a qualified contractor. Fasteners listed are only
suggestions and should be chosen to best fit the needs
of your specific application.
24" level
Screwdriver
Tape measure, pencil
Silicone caulk
IMPORTANT SAFETY CAUTIONS:

Due to variances in local building codes and requirements, the installation instructions
provided here are only suggestions. IT IS STRONGLY ADVISED that you contact a
qualified contractor for application specific advice.

CareGiver
®
Fold-Down Shower Seats are only as strong as the strength and rigidity of the
material to which they are mounted.

The seat is intended for sitting purposes only. ONE person at a time. DO NOT attempt to
stand, kneel or use the seat for any other purpose other than sitting.

The seat is designed to withstand 400 lbs. – when properly installed. Improper installation
may cause bodily harm.

IMMEDIATELY DISCONTINUE use of the seat if visual signs of fatigue or wear become
evident. Regular inspections should be made to confirm that the seat is not pulling
away from the wall. If the wall brackets start to pull away from the wall IMMEDIATELY
discontinue use and call a qualified contractor.
In installing from new construction, a steel backer plate with the seat bolted to the plate (through the shower wall) using
fender washers is the preferred mounting method.
PREPARATION:
Model 390.409 Rectangular Seat
(Shown in down/useable position)
Up/storage position
Support
Arm
Upper
Mounting
Bracket
Guide
Bracket
Check local code for proper placement
of Fold-Down Padded Seats to meet
requirement such as ADA or ANSI 117.1
Consumer Safety Requirements.
Before installing the Fold-Down Padded
Seat you will have to prepare the area.
ROUGH-IN INSTALLATION: Determine
where the Fold-Down Padded Seat
will be mounted and install bracing to
the rough-in framing to support the
seat through the shower wall. Provide
no smaller than a 2" x 6" blocking in
the wall for mounting. Measure from
the sub-floor up 13
1
/
4
". Center the 2"
x 6" horizontally over three wall studs
and with the center of the 2" x 6" at the
13
1
/
4
" mark.
Notch wall studs to accommodate the
header and attached with no less than
Six (6) –
5
/
16
" x 3" stainless steel lag
screws. (as shown in Fig. 1a)
Before finishing the wall, and using the
dimensions of your seat, ensure that the
two upper mounting brackets and the
top two screws of the guide bracket will
line up with the 2" x 6" blocking, while
the third bottom screw of the guide
bracket will line up with the middle and
wall stud. (as shown in Fig. 1b)
Finish the stud wall with tile, Mustee
fiberglass shower wall kit or other.
E.L. Mustee & Sons, Inc.
5431 West 164th St.
Brook Park, OH 44142
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.mustee.com
INSTALLATION INSTRUCTIONS