Instructions / Assembly

• Designed for Mustee Wall Surround or any other wall surround.
• Fits alcove windows up to 36” wide.
• Kit material can easily be trimmed with simple hand tools - no power tools required.
• Tool required (scissors, utility knife), ruler, adhesive, and caulk.
MODEL 52.600W
E.L. MUSTEE & SONS, INC.
BROOK PARK, OHIO 44142
SI-135 (08•13)
EASY TO INSTALL:
1. Remove original window molding or trim that protrudes into bath aclove area. Measure width and depth of sill - as
measured to front face of window. Cut Formed Sill to t, be sure bonding surface is clean, apply adhesive directly to
2. Measure height of Formed Side Panel to align with top edge of wall surround (recommended), cut to height and
surface, press Formed Sill in place.
depth. Be sure bonding surface is clean. Apply adhesive directly to surface, press Formed Side Panel in place.
Repeat procedure for remaining Formed Side Panel,. Block and brace as needed until adhesive sets up.
(Approx. 24 Hours)
3. Caulk all seams as shown in illustration - smallest bead possible.
FORMED SIDE
PANEL L. H.
FORMED SILL
FORMED SIDE
PANEL R. H.
CAULK THIS AREA
(BOTH SIDES)
This will
FAILURE
After cleaning excess adhesive with the proper material as specified by adhesive manufacturer -
SPECIAL NOTICE!!
IMMEDIATELY WASH UNIT COMPLETELY WITH A SOAP WATER SOLUTION.
neutralize any continuing chemical reaction between the solvent and window kit material.
TO WASH AWAY SOLVENT MAY CAUSE BLEACHING OR LOSS OF COLOR IN WINDOW KIT
MATERIAL
DURATRIM
Window Kit
TM
MUSTEE
Preferred by the “Pros”
R










