Installation Guide

ManualsBrandsMUSTEE ManualsBathDurawall 42 in. x 72 in. x 58 in. 5-piece Easy Up Adhesive Bath Tub Wall in White

TOOLS AND MATERIALS NEEDED:

• Electric or Hand Drill • Hole Saw • Caulking Gun • Caulking

• Tape Measure • Level (24" Min.) • Grease Pencil • Adjustable Wrench

• Razor Knife • Masking Tape (2” wide) • Mineral Spirits • Screwdrivers (Std. & Phillips)

• Adhesive*

*Recommend LIQUID NAILS

for TUB SURROUNDS & SHOWER WALLS (LN-915)

NOTICE:

We recommend that tub/shower compartments be equipped with support Grab Bars that comply with ANSI-117.1 - 1986

requirements. Grab Bars must be anchored to structural support behind panels. Do Not rely on panels only for grab bar

support.

PREPARATION:

We do not recommend installing the Durawall

Bathtub Wall Panels over any existing tile surfaces.

The Durawall

Bathtub Wall may be installed over drywall, plaster, painted walls, plywood, or any solid wall- not

open studs. Wall surfaces must be clean, dry and free of grease, dust and loose or flakey paint or plaster. Shiny

smooth surfaces should be sanded or scratched to insure a positive bond.

E.L. MUSTEE & SONS, INC.

5431 West 164th Street • Brook Park, Ohio 44142

Sl-180 (9•06)

INSTALLATION INSTRUCTIONS

MODEL 56

MUSTEE

DURAWALL

5 PC. BATHTUB WALLS

“”

FITS BATHTUB ALCOVES UP TO

42” DEEP X 72” WIDE

Sl-180 (9 •06)

CARE AND CLEANING

The surface of your Durawall

Bathtub Wall may be cleaned with a mild soap solution in warm water using a soft

cloth. For stubborn stains use “Soft -Scrub” by Clorox or Lysol “Tub & Tile Cleaner” or a powdered detergent such as

“Spic-n-Span”. Never use abrasive scouring powder or steel wool pads as they will scratch the surface. A periodic

coating of a silicone based marine polish will help retain the fine finish.

Clean any excess adhesive – immediately

with mineral spirits – then wash area with a

soap water solution.

Wait approximately 12 hours before apply-

ing caulking. Remember to caulk around

faucet spout and handle hole(s). Follow

caulking instructions for clean up of excess

caulk.

Replace faucet spout and handle(s), turn on

water supply to bathtub alcove. Wait 24

hours before using tub or shower.