User's Manual
Table Of Contents
- Safety and Precautions
- Contents
- Supported Devices
- Unpack
- Scanner Parts
- LED Messages
- Insert AAA Batteries
- Set the Resolution
- Set the Scanner Mode
- Install the iScanAir Go app (Wi-Fi Mode)
- Connect to Wireless Network (Wi-Fi Mode)
- Scan, Save, and Share (Wi-Fi Mode)
- Use as the Standalone Scanner (MicroSD Mode)
- Clean Lens and Rollers
- Calibrate
- Helpful Hints
- Specifications
13
Scan, Save, and Share (Wi-Fi Mode)
•
Ensure the Scanner is switched to the “Wi-Fi” mode on
the side of the Scanner, and is connected to your device
prior to use. (See p.12)
•
Make sure your device is supported. (See p.4)
NOTES
Scan the Object
1. Press iScanAir Go app on your device to open it,
then press Start.
* For Windows 8, swipe in or mouse in from the right edge of
the screen. Select "File Format" from the menu, and choose
"Scan to JPG" or "Scan to PDF".
2. Place the Scanner on the object with the scanning
lens facing down, making sure the scanned area is
located between the two arrows on the scanner.
3. Press the POWER/SCAN button to start scanning.
* The Wi-Fi LED ( ) will blink a purple light.
4. Move the scanner slowly and steadily down towards
the bottom of the object, press the
POWER/SCAN
button again to end scanning.
* Ensure the Status LED ( ) blink green light at the normal
speed during scanning.
(continued on the next page)
Press POWER/SCAN to end.
* The app looks slightly different
depending on your device's
operating system
Press Start.