User Manual

7
NOTE:
USB power
adapter not included. Use
the USB power adapter
provided with your mobile
device to connect a
power socket.
Charge the Battery
Wireless Scanner has a built-in rechargeable
battery to provide power, make sure it has been
fully charged before use.
1. Press POWER button to turn Off the Scanner.
* The Power LED indicator shall turn off.
2. Connect the USB cable to the Scanner at
small end and to a computer (
A
) or to USB
power adapter (
B
) at the other end.
* The Power LED indicator shall emit red light to
indicate the battery is charging.
3. Once the battery is fully charged, the Power
LED shall turn off, then disconnect the USB
cable from the Scanner.
E
:
USB
powe
r
A
B
•
Charge the Scanner for approximately 4 hours or
until the Power LED indicator turns off.
•
When a low battery alerts (a green Power LED
blinks), charge the Scanner immediately.
•
Scanner will not charge while operating. Ensure
Scanner’s power is off when charging battery.
•
The rechargeable battery is consumable. The
battery capacity will decreased gradually.
NOTES
NOTES