Specifications

TP-5700/5800 series Technical Manual 7 - 2
edge of the main unit and fasten the two screws with washer as indicated in the picture.
Route the cable with or without an extension cable through the side of the cable cover
to proper port. Break the obstructing sidewall of the cable cover at the cable entrance
to the connector area.
REAR TOP MOUNT UPGRADE KIT
The upgrade kit that can be mounted on rear top of the whole Jiva
series (all TP series) is PD302, a 2 by 20 LCD customer display.
Separate the main unit from its stand assembly. Prepare power for the
PD302 in the service window on rear side of the main unit and then
reunite the touch terminal.
1. Aim the bottom center cavity of PD302 series toward the
latch stub at rear of touch terminal main unit. Then aim both
metal and plastic hooks at rear of the PD302 series toward
the suitable ventilation openings on top rear of the main
unit. Please use a phillips head driver to fasten the screws
on the metal hook but not to overdo it so that the metal
hooks hold the ribs of the ventilation holes from inside.
2. Plug the DB9 female connector to the COM port with power DC supply from the TP
series. If the COM1 terminator is found on COM1 port that happens to be the COM
port planed for PD302, please remove the COM1 terminator and save it at a safe
place for future use.
3. Route the cable to go through the notch on back of the stand assembly
of touch terminal as indicated in the picture. Reassemble the main
unit and stand assembly.
Side Mount
Screw
Metal hook Plastic hook