Specifications

TP-5700/5800 series Technical Manual 7 - 4
cover plate, remove the cover plate, and remove the riser card from the opening before
completely removing the LCD panel assembly.
However, if the mechanical structure of the system is already of a newer version
that we call it as snap-on structure and utilizes minimal number of screws in assembly
as in pictures below a lot of unscrewing operations are eliminated. Press down the 2
springs on bottom side of LCD panel assembly and lift the LCD panel assembly by top
edges. Don’t pull the 2 lugs easily visible for this operation because they actually
belong to the lower part. Just press down the spring located at right side to the riser
card cover plate and meantime push this cover plate to the right to show the riser card.
Now, please disconnect the three cables (LCD display cable, touch controller
cable and inverter cable) from the riser card and also the LCD panel assembly for
replacement of the riser card. Disconnect the connector(s) on the inverter board and
unscrew four screws to release the LCD panel from the metal frame. Unscrew two
screws to remove the inverter board. The touch control panel is fixed on the metal
frame as an individual service part. Please pay particular attention to the routing of the
three cables during the reverse process for reassembling. Please also make sure that in
the reassembly process, the edge of the riser card is secured in the openings of the riser
card cover plate.
REPLACE HDD (only for TP5815)
3 screws each side
4 screws on riser card plate
Riser card
Î
š
Î
1. Push springs down
2. Don’t pull the lugs!
Raise the top edges!
3. Push the spring down
4. Push cover right
š