User manual

Battery Level, Charging and Indicators
Th e battery le vel status is shown by a battery symbol upon the normal screen.
Connect the
supplied USB charging cable to a PC, or use one of the mains to
USB adaptors supplied, to charge the Internet radio.
~hen the USB battery charging commences, the power indicator glows Red
th
he
b~ttery can be charged during normal operation of the radio however if
. e r~ 10 IS operating and charging simultaneously, then the cha:ge indicator
t
iS ye ow . When the battery is fully charged, the char ge indicator goes out or
urns green, If the radio
is in use. '
When the battery is running l ow, the battery icon fla shes.
If .;~ e battery becomes critically low, the radio wil l power OFF automatically and
WI not re-start until the battery IS charged, or USB power is applied.
Note: Th e in ternal battery is NOT a user replaceable part and carries a 1
wa
rr anty. year
Troubleshooting
If problems occur when connecting the radio to the wireless network, ple ase try
as follows:
1. When scanning for a Wi-Fi network and nothing is found, please make sure
yo ur reception area has an e ffe ctive Wi-Fi network coverage.
2. When scanning for a Wi- Fi network, the radio may prompt yo u that "You
connect too many APs, p lea se delete one and scan again." Thi s means you
have exceeded the limit of three stored networks in memory. Please remo ve one
netwo
rk from the Stored Networks and then scan for networks aga in .
3. When you have scanned for a Wi-
Fi network but still can not connect to
it,
please check whether the selected network is encrypted . If it is encrypted,
pl ease select the correct encryption method and enter the correct ke y to gain
access.
If still not connected, please select the Automatic (D HCP) option in the Edi t
Settings from the Network Menu and then try again;
If unable to connect to a Wi-Fi netwo rk, please set to "D isable Po wer Saving" in
the Po wer Sav ing op ti on from the Net wo rk Menu and try again;
If still un ab le to connect, please confirm wheth er the Wireless Network Access
Point has firewall and MAC address filtering, if so, please stop MAC address
filtering or add the device
MAC address within the AP list of a ll owed addresses
and try again;
If still unable to connect, please check whether the Wi reless Network Access
Poi nt requir es a fixed IP address (Static IP ). If so, please select Manual (Static IP )
in Edit Settings from the Network Menu. Ent er the co rr ect network information
If a connection can still not be established, please contact the network access