Manual

\\\\\\\\\\\\

INSTALLATION

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Manual SDs-01 D 3.2.2003 17:45 Uhr Seite 8

bridge, you can use an additional BNC-T piece to terminate the input. Plug

the T piece with its center connector into the input of the receiving device.

Then, connect the cable coming from the MC-4’s Word Clock output to one

of the lateral connectors, and the other connector of the BNC-T piece to a

75 Ω resistor forming the BNC termination.

Basically, you should avoid »looping through« Word Clock leads by means

of passive BNC-T pieces to preserve the signal quality, as level drops will be

the result. If there is no other way to wire your set-up, please make sure

that all Word Clock inputs (except for the last device in the chain) have

their terminations disabled! In a serial Word Clock chain only the last clock

input should have a termination! Never connect more than three devices in

series to one output!