Technical data

ManualsBrandsMUTEC ManualsAudioMC-4







!

CONTROL ELEMENTS AND TERMINALS

MC-6 Front Panel

1 POWER

This red LED lights up when the unit is switched on with the rear panel

POWER switch.

2 MENU

The push-button selects one of the available function menus.

3 SELECT

Use this push-button to select a function within a specific function menu.

4 MODE + AUDIO

This function menu allows to adjust all available conversion modes (LED

line »MODE«) in combination with the corresponding digital audio formats

(LED line »AUDIO IN«) .

5 REFERENCE

This function menu allows to select the master clock reference for synchro-

nization of the format conversion section as well as the SRCs.

6 STATUS

This menu indicates various signal statuses of the incoming master clock

reference signal and the digital audio signal. For details see page 25.

7 REF CLOCK IN

This menu indicates the clock rates of the incoming digital audio signal or

of the master clock reference signal. For details see page 25.

MC-6 Rear Panel

1 AES3id OUT + WCLK OUT

The first output above transmits an AES3id digital audio stereo signal in

compliance with the AES3id–2001 standard. The second output below

transmits a low-jitter Word Clock signal based on the selected external refe-

rence clock or the internal clock basis. The impedances of both connectors

are 75 Ω (BNC connectors, female).

2 S/P-DIF OUT

These two S/P-DIF outputs, available as optical (»OP«) and coaxial (»CO«)

interfaces, transmit an optical S/P-DIF and an unbalanced electrical S/P-DIF

digital audio or blank frame signal in compliance with the IEC 60958 stand-

ard. The coaxial interface impedance is 75 Ω. (cinch connector), the optical

interface offers a Toshiba Toslink

connector, EIAJ standard.

3 AES3 OUT

This AES/EBU output transmits a transformer-balanced electrical AES3 or

AES11 signal in compliance with AES3 –1992 (R1997) standard. The output

impedance is 110 Ω (XLR connector, male).

Refer to the OPERATIONS chapter for more

information.

For detailed specifications on all terminals,

refer to the »Pin Assignment of the

Connectors« and »Technical Data« in the

chapter »APPENDIX«.

2 6

7 8

5 6

4 5

4 4