System information
When the Automation Settings button in the Faders control region is not selected, click the Channel
Send button and choose a bus or assignable effects chain from the menu, and then drag the fader to
adjust the send level.
When the Automation Settings button in the Faders control region is selected, the fader handle is
displayed as a , and you can use it to edit send volume automation on the track.
The trim level is added to the automation settings so your envelope is preserved, but with a boost or
cut applied. For example, setting the trim control to -3 dB has the same effect as decreasing every
envelope point by 3 dB.
To adjust the size of the Sends control region, you can drag the bottom divider to make more or fewer
sends visible.
Bus sends are pre-volume (and pre-mute) by default. When bus sends are pre-volume, you can create a cue
mix that is independent of your main mix. For more information, see "Creating a Cue (Headphone) Mix
with the Mixing Console" on page 382. To change to post-volume (and post-mute), click the Pre/Post
button to switch to Post Volume Send mode.
Changing a track's input or output device
When the I/O control region is visible, each track displays controls you can use to set the track's input device
(for recording) and output device.
To show or hide the I/O control region, click the I/O button in the View Controls pane.
To choose the recording input for the track, click the Input button and choose a port from the menu:
To route a track to a bus, click the Output button and choose a bus from the menu:
THE MIXING CONSOLE357