System information
Setting Description
Auto Edit Select this radio button if your deck supports Auto Edit/Insert Edit
mode.
When using Auto Edit mode, use a striped tape to ensure
continuous timecode over the portion of the tape where you
plan to record.
a. Select the Preview only check box if you want to preview your
print-to-tape operation without engaging the deck's record
head.
Use Preview only mode to double-check and adjust your
Start printing at timecode setting as needed.
b. The Start printing at box displays the current device timecode
location. You can cue the tape or type a value to indicate
where you want to begin recording. The End at box displays
the frame where recording will end (much like punch-in audio
recording).
c. When you click Next, the Select Channels page is displayed.
d. On the Select Channels page, select a radio button to choose
which channels you want to print to tape:
n Write all rendered channels: select this radio button
to print video and all audio channels to tape
n Write only selected channels: select this radio button
if you want to choose which channels you want to
print to tape. Select the check box for each channel
you want to print.
7. Click Finish. If you have not already prerendered, portions of your project that cannot be rendered
and printed to tape in real time will be selectively prerendered. For more information, see "Selectively
Prerender Video" on page 478.
n If you're using Manual mode, a dialog will be displayed after rendering is finished. You can
specify a delay time in the Delay playback countdown timer box and select the Beep each
second during countdown check box if you want to count down before sending video to
your device.
n If you're using Crash recording mode, your DV recorder will start and begin recording after
rendering is finished.
n If you're using Auto Edit mode, recording will begin and end automatically at the specified
timecode positions.
506CHAPTER 28