System information
Navigating the timeline
When playback is paused and the Scrub button is not selected, the jog dial performs the following
functions:
n When the Zoom button is not selected, turn the dial clockwise or counterclockwise to navigate the
timeline by frames.
n When the Zoom button is selected, turn the dial clockwise or counterclockwise to navigate the
timeline by pixels.
n Hold the Shift button and turn the dial to create a time selection or extend a selection.
Scrubbing the timeline
During playback, turning the jog dial increases or decreases the playback rate.
When playback is paused and the Scrub button is selected, turning the jog dial scrubs the timeline.
Trimming events
1. Press the Event Trim button to enter event trimming mode.
2. Press the left or right arrow button to select the event edge you want to trim. A red bracket is
displayed to indicate which event edge will be trimmed.
3. Turn the jog dial to trim the event edge left or right in one-frame increments. Hold Ctrl while turning
the dial to trim in one-pixel increments. Depending on the current zoom level, the trim duration will
vary.
For more information, see "Adjusting an Event's Length" on page 158 and "Zooming and
magnification" on page 188.
Using a Frontier TranzPort
Using a Frontier TranzPort, you can control Vegas Pro wirelessly.
For more information about configuring Vegas Pro to use a control surface, see "Using a Control Surface"
on page 529.
View the control mappings
The map for the TranzPort assigns the controls as follows.
546CHAPTER 30