System information
Item Description
Smooth and thin
automation data after
recording
When recording automation, Vegas Pro creates as many envelope
points or keyframes as possible to represent your control movements.
Select this check box if you want to reduce the number of envelope
points/keyframes after recording is finished. For more information,
see "Recording Track Envelope and Keyframe Automation" on page
270.
Set controls to default
values when
automation is turned
off
Select this check box if you want controls to return to their default
values when set the track's automation recording mode to
Automation Off. Automated effect parameters do not have default
settings and will retain their last-set values when you turn automation
off.
When the check box is cleared, controls will retain their last-set values
when you turn automation off. For more information, see "Recording
Track Envelope and Keyframe Automation" on page 270.
Available devices Choose a device from each drop-down list, and then click Add to
choose the control surfaces that will be available to Vegas Pro.
Adding a device loads its default profile.
n For information about setting up and using a control surface,
see "Using a Control Surface" on page 529.
n For information about using a Mackie Control Universal, see
"Using a Mackie Control" on page 531.
n For information about using a Frontier TranzPort, see "Using a
Frontier TranzPort" on page 546.
n For information about using a PreSonus FaderPort, see "Using
a PreSonus FaderPort" on page 548.
n For information about using a generic control surface, see
"Using a Generic Control Surface" on page 550.
Active control devices Lists the control devices that you've added. If you want to customize
the behavior of the controller, double-click the device name.
New audio envelopes Choose a setting from the drop-down list to set the default fade type
that will be used when you add volume and panning envelopes. For
more information, see "Audio Track Automation" on page 255.
This setting is used only when you create new envelopes. When you
add a point to an existing envelope, the new point always uses the
same fade type as the preceding envelope point.
612CHAPTER 32