Specifications

Falcon II Outdoor series printers – Maintenance Manual
19
AP-74065, Rev. 1.0, 21/11/03
7 Media cut groove Only onto the Falcon II Outdoor 4H printer !
Used to cut the media straight when it is cut manually.
8 Carriage cover Only onto the Falcon II Outdoor printer !
This is a cover to protect the user from the internal components of the
unit. This is opened during following operation :
¾ When cleaning the cleaning wiper
9 Foot switch This switch is used to raise and lower the pressure rollers.
10 Paper Guide Support the media during printing
In the Falcon II Outdoor it houses post-heater (dryer).
In the Falcon II Outdoor 4H it houses the fixer, post-fixer and dryer.
2.3.2. Back
No. Name Function
1 AC inlet This is the inlet interface to which the power plug is connected.
2 Interface connector This is the connector to which the interface cable is connected.
3 Foot switch connector This is the connector to which the foot switch cable is attached.
4 Insertion slot This is the slot for inserting media when loading it.
5 Interface slot 1 The network interface board attaches here.
6 Interface slot 2
7 Interface slot 3
This is not used for this printer.
Close it with the cover.
8 Hard disk slot The hard disk attaches here. When not using a hard disk, keep the
cover closed.
9 Nameplate rating The type, name, serial number, rating and other details of the printer are
labelled here.
10 Rear Heater Supports the media during printing and houses the pre-heaters.