Specifications

Falcon II Outdoor series printers – Maintenance Manual
206
AP-74065, Rev. 1.0, 21/11/03
5.9.8. Sequential Printing Endurance Menu
This menu performs endurance running for the printer heads.
You can operate the printer heads according to your desired settings. The available settings are shown below.
Setup item Description Parameters Remarks
Printing mode Set printing mode. MODE 1, MODE 2,
MODE 3, MODE 5,
MODE 6, MODE 7
Media Cut Sets whether to cut
media each time one
printing is printed out or
not.
Yes, No
Number of endurance
running cycles
Set the number of
endurance running
cycles
-1 to 10000
Notes :
¾ If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
¾ The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
* Print Mode *
F1 →
MODE1 MODE2
← F2
F3 →
MODE3 MODE5
← F4
(1/2)
* Print Mode *
F1 →
MODE6 MODE7
← F2
(2/2)
↓ Select mode
* Cut *
Cut Yes/No +
Yes -
↓ ENTER
* Nozzle *
Count
-1 → 10000 +
Number of endurance running cycles
50 -
↓ ENTER