Specifications

Falcon II Outdoor series printers – Maintenance Manual
312
AP-74065, Rev. 1.0, 21/11/03
(8) Check if the
remaining amount of
ink in the cartridge
is sufficient.
• If “Near End” or
“Ink End” is not
displayed when the
remaining amount of
ink is insufficient,
the ink sensor
assembly may have
a problem.
→ Replacing the I/H
(inkholder)
assembly.
(9) The ink pump
assembly may have
a problem.
• Replace the ink
pump assembly.
→ Replacing the
pump assembly.
(10) The
maintenance
assembly may have
a problem.
• Replace the
maintenance
assembly.
→ Replacing the
maintenance
assembly
(11) The Mainboard
assembly may have
a problem.
• Replace the
Mainboard
assembly.
→ Replacing the
print head assembly
and head tape
power cable.
5 Nothing has been printed (1) Check the head
and CR cables for
skewed insertion.
• Redo the
connections of the
following
connectors.
Connectors for the
print head.
• CR board : J201 –
J232
• Mainboard : J137
– J152
→ Replacing the
print head assembly
and head tape
power cable.
→ Replacing the CR
board assembly.
→ Replacing the
print head assembly
and head tape
power cable.
(2) The head and
CR cables may be
damaged.
• Replace the CR
tape power cables.
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
(3) Check ink tubes
for bends, flaws, air
leaks, etc.
• Replace the
damaged ink tubes.
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
(4) The print head
assembly may be
damaged.
• Replace the print
head assembly.
→ Replacing the
print head assembly
and head tape
power cable.
(5) The damper may
be damaged.
• Replace the
damaged cable.
→ Replacing the H
ink tube, tube
branch and damper
assembly.
(6) The ink pump
assembly may have
a problem.
• Replace the ink
pump assembly.
→ Replacing the
pump assembly.
6 Only specific colours are not
printed.
(7) The
maintenance
assembly may have
a problem.
• Replace the
maintenance
assembly.
→ Replacing the
maintenance
assembly.